Headlight Adiustment
Note: The headlight can be adjusted by means of vertical and horizontal adjustment screws located on the rear of the headlight.
1. Horizontal adjustment screw; 2. Vertical adjustment screw; 3. Headlight adjuster lever for loaded conditions
1. Switch the headlight dipped beam on.
2. Turn the vertical adjustment screw on the headlight clockwise to raise the beam or anti-clockwise to lower the beam.
3. Turn the horizontal adjustment screw clockwise to move the beam to the right or anti-clockwise to move the beam to the left.
4. Switch the headlights off when the beam settings are satisfactory.
Warning: Adjust road speed to suit the visibility and weather conditions in which the motorcycle is being operated. Ensure that the beam is adjusted to illuminate the road surface sufficiently far ahead without dazzling oncoming traffic. An incorrectly adjusted headlight may impair visibility causing an accident.
Warning: Never attempt to adjust a headlight beam when the motorcycle is in motion. Any attempt to adjust a headlight beam when the motorcycle is in motion may result in loss of control and an accident.
Headlight Bulb Replacement
1. Bulb retainer (right hand shown); 2. Bulb retainer hook; 3. Bulb
Each headlight bulb can be replaced as follows:
Warning: The bulb becomes hot during use. Always allow sufficient time for the bulb to cool before handling. Avoid touching the glass part of the bulb. If the glass is touched or gets dirty, clean with alcohol before re-use.
Warning: Do not reconnect the battery until the assembly process has been completed. Premature battery reconnection could result in ignition of the battery gases causing risk of injury.
1. Remove the rider's seat (see page 16-13).
2. Disconnect the battery, negative (black) lead first.
3. Remove the bulb cover from the bulb to be replaced by rotating it anti-clockwise.
4. Disconnect the multi-plug from the bulb retainer.
5. Detach the bulb retainer from the hook on the headlight assembly and rotate it away from the bulb as shown.
6. Remove the bulb from the bulb retainer.
Installation
1. Installation is the reverse of removal, noting the following:
Note: When reconnecting the battery, connect the positive (red) lead first.
Position Lamp Bulb Replacement
Note: The position lamp is fitted to the centre of the headlight.
1. Remove the rider's seat (see-page 16-13).
2. Disconnect the battery, negative (black) lead first.
3. Remove the four fixings and remove the headlight surround.
1. Headlamp surround; 2. Fixings
4. Detach the rubber retainer from the headlight and pull out the bulb.
1. Bulb retainer; 2. Position lamp bulb
Installation
1. Installation is the reverse of removal, noting the following:
Note:
- Tighten the headlight surround fixings to 3 Nm.
- Reconnect the battery, positive (red) lead first.