Caution: Disconnect ground lead from battery and insulate.
- Remove left and right fairing side sections.
See Group 46.
- Remove right-hand handlebar trim.
- Remove cover of fork bridge.
Removing and installing right multi-function switch
Warning: Comply with safety precautions when handling or working with fuel.
- Remove fuel tank.
- Remove the intake air pipe.
- Remove the air output from the right-hand radiator.
- Press radiator out of holder.
![](https://motoinstruction.ru/img/bmw/21/127587.jpg)
- Release the fasteners (arrows) and remove the bottom cover of the electronics box.
![](https://motoinstruction.ru/img/bmw/21/127588.jpg)
![](https://motoinstruction.ru/img/bmw/21/127589.jpg)
- Open the cable ties (arrows).
- Disconnect plugs (8) in electronics box.
- Disconnect plug (7) at fairing bracket.
- Pull cable through toward handlebar.
- Release fasteners (3) and take off lower cover (4).
- Release fasteners (5, 6) and remove multi-function switch.
- Installation is the reverse of the removal procedure: pay particular attention to the following.
- Make sure that the seal in the cover of the electronics box is correctly seated.
Removing brake light switch
![](https://motoinstruction.ru/img/bmw/21/127590.jpg)
- Open the cable ties (arrows).
- Disconnect plug (9) and pull cable through toward handlebar.
- Release fasteners (3) and take off lower cover (4).
- Release fastener (2) and remove brake-light switch (1).
- Installation is the reverse of the removal procedure: pay particular attention to the following.
- Make sure that the seal in the cover of the electronics box is correctly seated.