- Remove left and right fairing side sections.
Warning: Comply with safety precautions when handling or working with fuel.
- Remove fuel tank.
- Carefully remove the sealing lacquer from the tapped bore for grubscrew (1).
- Remove the grubscrew.
- Pull housing of ignition light switch (2) with cable down to remove.
- Open the cable ties (arrows).
- Open the lid of the electronics box.
- Disconnect plug (3).
- Remove ignition light switch housing.
- Installation is the reverse of the removal procedure: pay particular attention to the following.
- Seal the tapped bore for the grubscrew with sealing lacquer.
- Carefully route the cable and secure in position with cable ties.
- Make sure that the seal in the cover of the electronics box is correctly seated.