Note: Do not touch inside of reflector and glass of bulbs with bare hands.
- Bulb for low-beam headlight/high-beam headlight
- Press retaining clip (3) down and remove the housing cover (1).
Low (dipped) beam headlight
- Disconnect plug housing from bulb for low-beam headlight (4).
- Release spring clamps at top and bottom from retainer and remove the H7 bulb.
- Installation is the reverse of the removal procedure.
High (main) beam headlight
- Disconnect plug (1).
- Bend back the ground clip (2) of the bulb for high-beam headlight and remove the bulb holder.
- Use a screwdriver to press in the retaining lugs on left and right and disassemble the bulb holder.
- Remove the H3 bulb from its ring.
- Installation is the reverse of the removal procedure.
Bulb, parking light
- Working from in front, pull the bulb holder (arrow) down and out of the headlamp housing and replace the bulb.
- Push the bulb holder home into its mount.
Front turn signal
- Release the fastener and remove the turn signal.
- Change the bulb.
Rear lights
- Open side case on left or right, as appropriate.
- Release the fastener (arrow) and remove the taillight unit.
- Replace the appropriate bulb.
- Installation is the reverse of the removal procedure: pay particular attention to the following.
Caution: When changing the rear and brake light bulbs, do not accidentally confuse their contacts.
Colours of the wires in the socket for tail light/brake light
- Grey-yellow (3)
- Brown (4)
- Grey-blue (5)
Note: Make sure that the gap between the tail-light unit and the side case on left and right is uniform.