Front speakers
Preparatory work
- Remove upper section of fairing.
See Group 46.
- Remove interior trim.
- Release the cable straps (arrows).
- Disconnect plug (9).
- Remove screws (3) and remove speaker bezel (4) together with treble speaker.
Treble speaker
- Carefully straighten retaining lugs (arrow) on speaker bezel (4) and remove treble speaker (2).
Bass speaker
- Carefully lift bass speaker (5) clear of retaining plate (1).
- Disconnect plug (6) and remove speaker.
Loudspeaker box
- Carefully lift bass speaker (5) clear of retaining plate (1).
- Pull cable (7) through grommet (8).
- Remove bottom reflector (10).
- [Left]. Remove control unit for cruise control.
See Group 65.
- [Right]. Remove intake duct.
See Group 46.
- Remove loudspeaker box.
- Installation is the reverse of the removal procedure.
Tightening torques:
- Reflector to fairing bracket — 9 Nm
- Retaining plate, cruise control control unit to fairing bracket — 8 Nm
Rear speakers
- Disengage retaining strap (6) from lower section of top case.
- Remove screws (arrows) and remove armrest (1) with speakers from top case.
- Disconnect contacts from speakers (2).
- Remove fasteners (4) and remove retainers (3).
- Remove treble loudspeaker (5), if necessary.
- Installation is the reverse of the removal procedure: pay particular attention to the following.
- Position treble loudspeaker over small aperture in armrest (1).
Tightening torque:
- Armrest to top case — 1 Nm