Stopwatch control in mode «Circle» done using the high beam button «Flash» (11, fig. 5), located on the left hand switch block.
If mode «Circle» on, first press «Flash» starts the stopwatch. Each subsequent press saves the current stopwatch value to memory (maximum - 30 values), displaying the saved value on the screen for 10 seconds.
If the memory is full, each press of the switch will cause the message «FULL» on the display for 3 seconds. For new data accumulation, memory must be freed.
If you disable the function «Circle» from the main menu, current stopwatch value (if it's running) will not be saved.
When the ignition is turned off, the function «Circle» turns off and the current stopwatch value is not saved.
If the stopwatch reaches 9 minutes 59 seconds and 99 hundredths of the reading and is not saved, it will start a new countdown from scratch. The new reading will be repeated cyclically until the reading is saved or until the function is turned off «Circle». If after enabling the function «Circle» less than 30 values are written to memory, new values will be stored until the memory is completely full.
Data for each lap can be viewed later using the function «Circle memory».
Mode «MEMORY OF CIRCLES»
Shows data saved in mode «Circle»: lap number, lap time, etc. To display this function, enter the menu and select the page «LAP MEME» («Circle memory»); hold down after pressing the MODE switch (1, fig. 9) in position B «▼» within three seconds. The data for the first round appears.
The screen will display the lap number, lap time, maximum speed and maximum rpm achieved on the lap.
Each pressing switch 1 (rice. 9) to position B «▼» will alternately show the saved data of all other laps, returning after the last to the first.
If you press and hold the MODE switch while lap data is displayed (pnc. 9) in position B «▼» within three seconds, all lap data is erased. If before this in the mode «Circle» The stopwatch was turned on - it turns off automatically.
To exit the mode of viewing the contents of the lap memory without resetting, press the MODE switch to position A «A». If the lap memory is completely free, when viewing the data for each lap, its time will be «0.00.00».
If during a lap the engine speed reaches the rev limiter, the indicator lamp will light up while viewing the lap data «Limiter rpm» (9, fig. 4).
