This function makes it possible to display and identify motorcycle faults. This makes it possible to detect and replace faulty components.
To use this function, enter the menu and select the page «ERROR» (error).
This page is present in the menu only if at least one error is detected. Otherwise page «ERROR» not displayed.
If multiple errors are present, they are displayed one at a time in a scrolling mode, each lasting three seconds.
In any case, more detailed diagnostics can be obtained using the Ducati Diagnostic System (Ducati electronic diagnostic system).
Attention! If an error is displayed, be sure to contact an authorized Ducati service center.
| Error message | Decoding | Decoding (English) | |
 | TPS | Throttle position sensor | Throttle position sensor |
| PRESS | Sensor pressure | Pressure sensor |
| COIL | Oil temperature sensor | Oil temperature sensor |
| T-AIR | Air temperature sensor | Air temperature sensor |
| BATT | Battery terminal voltage (LOW - low, HIGH - high) | Battery voltage LOW - HIGH |
| LAMB | Lambda probe/lambda heater | Lambda sensor and/or Lambda heater |
| FUEL | Reserve fuel level sensor | Fuel reserve sensor |
| COIL | Vertical and/or horizontal cylinder ignition coil | Horizontal and/or vertical cylinder coil |
| INJET | Vertical and/or horizontal cylinder injector | Horizontal and/or vertical cylinder injector |
| START | Contactor starter | Starter contactor |
| R INJ | Injector relay | Injection relay |
| PKUP | Engine speed sensor | Pickup sensor |
| SPEED | Speed sensor (if installed) | Speed sensor (if present) |
| IMMO | Immobilizer (no key; antenna is disconnected; the key is not recognized) | Immobilizer (Key missing or antenna disconnected or key not recognised) |
| CAN | Connection between dashboard and ECU (electronic engine control module) | CAN line (Communication between ECU and instrument panel) |
| LIGHT | Light relay | Lights relay |