Prepare
1. Remove seat. See Removing and installing seat.
2. Remove main fuse. See Power disconnect.
3. Remove rear fender. See Rear fender.
Remove
1. See Figure 8-36. Remove license plate lamp connector.
- a. Remove harness from retainers.
- b. Disconnect license plate lamp connector.
- c. Remove license plate lamp connector. See A.7 SUMITOMO MTW AND MTL UNSEALED CONNECTORS.
2. See Figure 8-37. Remove clip.
3. See Figure 8-38. Remove license plate lamp.
- a. Remove screws (1).
- b. Remove license plate lamp (2).
Install
FASTENER | TORQUE VALUE | |
License plate lamp screws | 0.8-1.2 Nm | 7-11 in·lbs |
Rear lighting harness retainer screw | 1.2-2.0 Nm | 11-17 in·lbs |
1. See Figure 8-38. Install license plate lamp.
- a. Install license plate lamp (2).
- b. Install screws (1). Tighten to 0.8-1.2 Nm (7-11 in·lbs).
2. See Figure 8-36. Install license plate lamp connector.
- a. Install license plate lamp connector. See A.7 SUMITOMO MTW AND MTL UNSEALED CONNECTORS.
- b. Connect license plate lamp connector.
- c. Install harness into retainers.
3. See Figure 8-37. Install clip. Tighten to 1.2-2.0 Nm (11-17 in·lbs).
![](https://motoinstruction.ru/img/harley/22/127920.jpg)
Figure 8-36. Rear Lighting Retainers and Connectors
![](https://motoinstruction.ru/img/harley/22/127921.jpg)
Figure 8-37. Retainer Clip
![](https://motoinstruction.ru/img/harley/22/127922.jpg)
Figure 8-38. License Plate Lamp: 1. Screw (2); 2. License plate lamp
Complete
1. Install rear fender. See Rear fender. 2. Install main fuse. See Power disconnect. 3. Install seat. See Removing and installing seat.
Warning: Be sure that all lights and switches operate properly before operating motorcycle. Low visibility of rider can result in death or serious injury.
4. Check operation of all lamps.