Disconnect power
Two different methods of disconnecting electrical power are used in this manual.
- Disconnect negative battery cable from ground stud.
- Remove main fuse.
Disconnect negative battery cable from ground stud when there is a possibility of injury caused by starter engagement (engine rotation).
Remove main fuse when there is a possibility of injury, caused by accidental vehicle start-up, or electrical equipment damage.
Disconnect Negative Battery Cable
1. Remove left side cover. See Side covers.
2. Remove front belt guard. See Belt guards.
Warning: To prevent accidental vehicle start-up, which could cause death or serious injury, disconnect negative (-) battery cable before proceeding.
3. See Figure 8-3. Remove negative battery ground cable (1) from ground stud (2).
Remove Main Fuse
1. Remove right side cover. See Side covers.
Warning: To prevent accidental vehicle start-up, which could cause death or serious injury, remove main fuse before proceeding.
2. See Figure 8-4. Remove main fuse.
Connect power
| FASTENER | TORQUE VALUE | |
| Battery ground stud | 6.0-10.0 Nm | 54-88 in·lbs |
Connect Negative Battery Cable
1. See Figure 8-3. Install negative battery ground cable (1) to ground stud (2). Tighten to 6.0-10.0 Nm (54-88 in·lbs).
2. Install front belt guard. See Belt guards.
3. Install left side cover. See Side covers.
Install Main Fuse
1. See Figure 8-4. Install main fuse.
2. Install right side cover. See Side covers.
Figure 8-3. Battery Ground Cable: 1. Negative battery cable; 2. Ground stud
Figure 8-4. Main Fuse