Prepare
1. Remove seat. See Removing and installing seat.
2. Remove main fuse. See Power disconnect.
3. Remove rear fender. See Rear fender.
4. Remove rear license plate bracket. See Rear license plate bracket.
Remove
1. See Figure 8-33. Disconnect tail lamp connector.
- a. Disconnect tail lamp connector.
- b. Remove harness from retainers.
2. See Figure 8-34. Remove tail lamp assembly.
- a. Remove screws (3).
- b. Remove tail lamp assembly (2).
Install
FASTENER | TORQUE VALUE | |
Tail lamp screws | 3.9-5.9 Nm | 35-52 in·lbs |
1. See Figure 8-34. Install tail lamp assembly.
- a. Install tail lamp assembly (2).
- b. See Figure 8-35. Install retainer clips.
- c. Install screws (3). Tighten to 3.9-5.9 Nm (35-52 in·lbs).
2. See Figure 8-33. Connect tail lamp connector.
- a. Install harness into retainers
- b. Connect tail lamp connector.
![](https://motoinstruction.ru/img/harley/22/127915.jpg)
Figure 8-33. Rear Lighting Retainers and Connectors
![](https://motoinstruction.ru/img/harley/22/127916.jpg)
Figure 8-34. Tail Lamp Assembly: 1. License plate module; 2. Tail lamp assembly; 3. Screws (4)
![](https://motoinstruction.ru/img/harley/22/127917.jpg)
Figure 8-35. Retainer Clips
Complete
1. Install rear license plate bracket. See Rear license plate bracket.
2. Install rear fender. See Rear fender.
3. Install main fuse. See Power disconnect.
4. Install seat. See Removing and installing seat.
Warning: Be sure that all lights and switches operate properly before operating motorcycle. Low visibility of rider can result in death or serious injury.
5. Check operation of all lamps.