Crankshaft Sensor (Service Code 21) (Kawasaki KLE 650)

0

Start the engine and switch the diagnosis mode to Dealer 1 mode to know all the problem that the DFI system has at the time of self-diagnosis. If the engine cannot be started, the self-diagnosis system does not detect dynamic condition of the crankshaft sensor. In this case, turn off the ignition switch and turn it on again to enter the Dealer 2 mode. In this mode, the system tells all the troubles which the DFI system had in both static and dynamic conditions.

Crankshaft Sensor Removal/Installation

• Refer to the Crankshaft Sensor Removal/Installation in the Electrical System chapter.

Crankshaft Sensor Inspection

The crankshaft sensor has no power source, and when the engine stops, the crankshaft sensor generates no signals.

• Cranking the engine and measure the peak voltage of the crankshaft sensor (See Crankshaft Sensor Inspection in the Electrical System) in order to check the sensor.
• Check the wiring for continuity, using the following diagram.

Crankshaft Sensor Circuit

See this article in russian language

Article about repair motorcycles «Kawasaki Versys 650» (2007-2025): «Crankshaft Sensor (Service Code 21)»: https://motoinstruction.ru/en/Kawasaki/Versys/KLE650/engine/fuel/116211 <a href="https://motoinstruction.ru/en/Kawasaki/Versys/KLE650/engine/fuel/116211">Crankshaft Sensor (Service Code 21)</a> - article about repair motorcycles «Kawasaki Versys 650» (2007-2025) from section «Fuel system». [url=https://motoinstruction.ru/en/Kawasaki/Versys/KLE650/engine/fuel/116211]Crankshaft Sensor (Service Code 21)[/url] - article about repair motorcycles «Kawasaki Versys 650» (2007-2025) from section «Fuel system».