Removal
1. Remove the rider's seat as described on page 17.9.
2. Disconnect the battery negative (black) lead first.
3. Raise and prop the fuel tank as described on page 11.98.
4. Disconnect the electrical multi-plug from the sensor.
![](https://motoinstruction.ru/img/triumph/7/114488.jpg)
1. MAP sensor; 2. Multi-plug
5. Unscrew the bolt securing the sensor to the intake duct.
6. Raise the sensor in order to disconnect the hose from below it.
Installation
1. Fit the sensor to the intake duct, reconnect the hose and tighten the bolt to 3 Nm.
2. Reconnect the multi-ptug.
3. Support the tank, remove and stow the tank prop, then lower the tank to the frame and secure it as described on page 11.99.
4. Reconnect the battery, positive (red) lead first.
5. Refit the rider's seat as described on page 17.9.