Warning!
- Make sure the motorcycle is stabilised and adequately supported.
- A correctly supported motorcycle will help prevent it from falling.
- An unstable motorcycle may fall, causing injury to the operator or damage to the motorcycle.
Note: Note that the right hand indicator harness can be identified by the red tape on it.
1. Feed the indicator harnesses into the upper moulding as noted for removal and connect them to the sub-harness.
2. Carefully attach the lower moulding to the upper moulding. Ensure that the mounting plate is positioned as noted for removal.
3. Secure the indicators onto the indicator hanger and tighten their fixings to 3 Nm.
4. Fit the licence plate bracket to the indicator hanger and tighten the:
- M5 screw to 3 Nm
- Lock nuts to 3 Nm.
1. M5 screw; 2. Lock nuts
5. Fit the rear reflector and secure in position with the clips.
Note: Ensure that the gasket is positioned as noted for removal.
Perform the following operations:
- Rear direction indicator hanger - installation
- Battery - installation
- Seat - installation
- Check the operation of the rear indicators and the licence plate light. Rectify if necessary.