Warning!
- Make sure the motorcycle is stabilised and adequately supported.
- A correctly supported motorcycle will help prevent it from falling.
- An unstable motorcycle may fall, causing injury to the operator or damage to the motorcycle.
Perform the following operations:
Caution! Note the routing and the retaining clips of the side stand switch harness for installation.
1. Disconnect the side stand switch electrical connector from the main harness and feed it down to the side stand switch.
![](https://motoinstruction.ru/img/triumph/15/122001.jpg)
1. Side stand switch electrical connector
Warning! Wear hand, eye and face protection when unhooking the stand spring. Take great care to minimise the risk of personal injury and loss of components.
Note: Note the orientation of the side stand spring for installation.
2. With the side stand in the up position, unhook the spring from the side stand and remove it from the motorcycle.
Note: Note the routing of the two hoses between the side stand switch heat shields for installation.
3. Release the fixings and remove the side stand and mounting assembly. At the same time remove the two hoses from between the two heat shields.
![](https://motoinstruction.ru/img/triumph/15/122002.jpg)
1. Fixings; 2. Hoses; 3. Side stand mounting; 4. Release the retaining clips and remove the heat shields
5. Release the fixings and remove the side stand switch. Discard the fixings.
![](https://motoinstruction.ru/img/triumph/15/122003.jpg)
1. Heat shield retaining clips; 2. Heat shields; 3. Switch fixings; 4. Switch