Gear position sensor — installation (Triumph Street Triple 765 R/RS)

0

1. Fit two new O-rings to the gear position sensor. Lubricate the O-rings with a smear of petroleum jelly.

2. Fit the gear position sensor to the engine. Ensure that the locating pin on the sensor fits into the hole in the end of the gear selector drum.



3. Fit the gear position sensor fixings and tighten to 5 Nm.

4. Route the gear position sensor as noted for removal and connect to the main harness.

Perform the following operations:

• Front sprocket cover - installation
• Gear change linkage - installation
• Fuel tank - installation
• Battery - installation
• Seat - installation

See this article in russian language

Article about repair motorcycles «Triumph Street Triple 765 R/RS» (2017-2024): «Gear position sensor — installation»: https://motoinstruction.ru/en/Triumph/Street-Triple/4/engine/fuel/113937 <a href="https://motoinstruction.ru/en/Triumph/Street-Triple/4/engine/fuel/113937">Gear position sensor — installation</a> - article about repair motorcycles «Triumph Street Triple 765 R/RS» (2017-2024) from section «Fuel and control system». [url=https://motoinstruction.ru/en/Triumph/Street-Triple/4/engine/fuel/113937]Gear position sensor — installation[/url] - article about repair motorcycles «Triumph Street Triple 765 R/RS» (2017-2024) from section «Fuel and control system».