Warning!
- Make sure the motorcycle is stabilised and adequately supported.
- A correctly supported motorcycle will help prevent it from falling.
- An unstable motorcycle may fall, causing injury to the operator or damage to the motorcycle.
Perform the following operations:
Note: Note that the stopper plate has an OUT mark. This must face outwards when fitted. There are spring seats located in the pressure plate. Ensure the seats are in the pressure plate prior to fitting the springs.
1. Release the 3 bolts, remove the stopper plate, springs, pressure plate and spring seats.
![](https://motoinstruction.ru/img/triumph/15/121235.jpg)
1. Bolts; 2. Stopper plate; 3. Springs; 4. Spring seats; 5. Pressure Plate
2. Remove the clutch pull-rod.
![](https://motoinstruction.ru/img/triumph/15/121236.jpg)
1. Clutch pull-rod; 2. Clutch pressure plate
3. Remove the clutch friction plates and steel plates together with the anti-judder spring and anti-judder seat washer.
Note: Record the orientation of all components as they are removed. The plates must be assembled in the same order.
Note: The inner and the two outermost friction plates are different to the other friction plates. They must be fitted in their noted positions. The outer steel plate is different to the other plates. It must be fitted in its noted position.
![](https://motoinstruction.ru/img/triumph/15/121237.jpg)
1. Outer friction plate; 2. Steel plate; 3. Anti-judder spring; 4. Anti-judder seat washer; 5. Clutch inner drum
Note:
- Store all plates in their correct fitted order to avoid confusion on installation.
- Refer to the following page of this section for details of clutch friction plate checking.
- It is not normally necessary to disassemble the clutch further, but if the clutch inner and outer drums are to be removed, proceed as follows:
4. Engage second gear and lock the inner and outer clutch drums together using T3880307 - Clutch Anti-rotation Jig.
![](https://motoinstruction.ru/img/triumph/15/121238.jpg)
1. T3880307 - Clutch Anti-rotation Jig
5. Depress the rear brake pedal to prevent the engine from turning, then release the clutch centre nut.
6. Remove the centre nut, Belleville washer, flat washer, clutch inner drum and thrust washer. Discard the nut and Belleville washer.
![](https://motoinstruction.ru/img/triumph/15/121239.jpg)
1. Centre nut; 2. Belleville washer; 3. Flat washer; 4. Inner drum; 5. Thrust washer
7. Slide the clutch outer drum assembly gently backwards and forwards to dislodge the inner bearing sleeve. Carefully remove the bearing sleeve while supporting the clutch outer drum.
![](https://motoinstruction.ru/img/triumph/15/121240.jpg)
1. Outer drum; 2. Bearing sleeve
8. Remove the clutch outer drum leaving the oil pump drive sprocket, bearing and sleeve in place on the input shaft.