Prepare
1. Remove engine. See Replace engine.
2. Remove starter. See Removing and installing starter.
3. Remove clutch. See Removing and installing clutch.
4. Remove cylinder head covers. See Cylinder head covers.
5. Remove cylinder heads. See Cylinder heads.
6. Remove cylinders. See Removing and installing cylinders.
7. Remove balancer shaft. See Removing and installing balancer.
8. Remove output pulley. See Output pulley.
9. Separate crankcase. See Crankcase assembly.
Remove
1. See Figure 4.45. Remove oil strainer.
- a. Remove screws (3).
- b. Remove plate (2).
- c. Remove oil strainer (1).
Install
| FASTENER | TORQUE VALUE | |
| Oil strainer fasteners | 10.0-12.0 Nm | 89-106 in·lbs |
1. See Figure 4.45. Install oil strainer.
- a. Install oil strainer (1).
- b. Install plate (2).
- c. Apply LOCTITE 243 MEDIUM STRENGTH THREADLOCKER AND SEALANT (blue) to screws (3).
- d. Install screws (3). Tighten to 10.0-12.0 Nm (89-106 in·lbs).
Figure 4-45. Oil Strainer: 1. Oil strainer; 2. Plate; 3. Screw (2)
Complete
1. Join crankcase halves. See Crankcase assembly.
2. Install output pulley. See Output pulley.
3. Install balancer shaft. See Removing and installing balancer.
4. Install cylinders. See Removing and installing cylinders.
5. Install cylinder heads. See Cylinder heads.
6. Install cylinder head covers. See Cylinder head covers.
7. Install clutch. See Removing and installing clutch.
8. Install starter. See Removing and installing starter.
9. Install engine. See Replace engine.