Сheck brake fluid level
Notes:
- Do not add or remove brake fluid from the system during normal wear. Reservoir volume is adequate to provide fluid to the wear limits of the pads and discs.
- Fluid level in reservoir will decrease with brake wear. If fluid level is low, check brake pads and discs for wear.
Front
1. Check front master cylinder reservoir fluid level.
- a. Set motorcycle upright and turn handlebar to level reservoir.
- b. See Figure 2-14. Check level in sight glass.
2. If fluid is below MIN mark:
- a. Check brake pad installation or for wear beyond specification. Replace or repair as necessary. See Inspect brakes.
- b. Check brake system for leaks. Repair as necessary.
Rear
1. Check rear master cylinder reservoir fluid level.
- a. Set motorcycle upright to level reservoir.
- b. See Figure 2-15. Check level in sight glass.
2. If fluid is below MIN mark:
- a. Check brake pad installation or for wear beyond specification. Replace or repair as necessary. See Inspect brakes.
- b. Check brake system for leaks. Repair as necessary.
Figure 2-14. Front Master Cylinder Reservoir Sight Glass
Figure 2-15. Rear Master Cylinder Reservoir Sight Glass
Drain and replace fluid
For this scheduled maintenance procedure, see Bleed brakes.