Clutch plate warp — inspection (Kawasaki ZX600-J1)

0

Place each friction plate or steel plate on a surface plate and measure the gap between the surface plate [A] and each friction plate or steel plate [B] with a thickness gauge [С]. The gap is the amount of friction or steel plate warp.



★ If any plate is warped over the service limit, replace it with a new one.

Friction and Steel Plate Warp
Standard: 0.2 mm or less
Service Limit: 0.3 mm

See this article in russian language

Article about repair motorcycles «Kawasaki ZX-6R ZX600-J1/J2» (2000-2002): «Clutch plate warp — inspection»: https://motoinstruction.ru/en/Kawasaki/ZX-6R/ZX600J/engine/transm/111335 <a href="https://motoinstruction.ru/en/Kawasaki/ZX-6R/ZX600J/engine/transm/111335">Clutch plate warp — inspection</a> - article about repair motorcycles «Kawasaki ZX-6R ZX600-J1/J2» (2000-2002) from section «Transmission». [url=https://motoinstruction.ru/en/Kawasaki/ZX-6R/ZX600J/engine/transm/111335]Clutch plate warp — inspection[/url] - article about repair motorcycles «Kawasaki ZX-6R ZX600-J1/J2» (2000-2002) from section «Transmission».