Prepare
1. Remove main fuse. See Power disconnect.
2. Remove headlamp fairing. See Headlamp fairing.
3. Remove handlebar. See Removing and installing handlebar.
4. Remove fuel tank. See Fuel tank.
Remove
1. See Figure 8-9. Disconnect ignition switch connector.
2. See Figure 8-10. Remove cap (1).
3. Remove upper fork bracket (4). See Front fork.
4. Remove ignition switch.
- a. Remove screws (5).
- b. Remove ignition switch (2).
Install
FASTENER | TORQUE VALUE | |
Ignition switch screws | 6.2-6.8 Nm | 55-60 in·lbs |
1. See Figure 8-10. Install ignition switch.
- a. Install ignition switch (2).
- b. Install screws (5). Tighten to 6.2-6 8 Nm (55-60 in·lbs).
- c. Cycle ignition switch to the fork lock position. Verify lock bar (3) operates smoothly.
2. Install upper fork bracket (4). See Front fork.
3. Install cap (1).
4. See Figure 8-9. Connect ignition switch connector.
![](https://motoinstruction.ru/img/harley/22/127891.jpg)
Figure 8-9. Ignition Switch Connector
![](https://motoinstruction.ru/img/harley/22/127892.jpg)
Figure 8-10. Ignition Switch: 1. Cap; 2. Ignition switch; 3. Lock bar; 4. Upper fork bracket; 5. Screw (2)
Complete
1. Install handlebar. See Removing and installing handlebar.
2. Install headlamp fairing. See Headlamp fairing.
3. Install fuel tank. See Fuel tank.
4. Install main fuse. See Power disconnect.
Warning: Be sure that all lights and switches operate properly before operating motorcycle. Low visibility of rider can result in death or serious injury.
5. Check operation of all lamps.