Removal
Warning: Before starting work, ensure the motorcycle is stabilised and adequately supported. This will help prevent it from falling and causing injury to the operator or damage to the motorcycle.
1. Remove the rear wheel (see page 15-12).
2. Remove and discard the four screws and remove the pulser ring.
1. Axle shaft; 2. Pulser ring; 3. Brake disc
Inspection
1. Check the pulser ring for damaged, missing or cracked teeth or distortion. Renew the pulser ring as necessary.
Installation
1. Locate the pulser ring to the rear brake disc.
2. Install new screws and tighten to 5 Nm.
3. Refit the rear wheel (see page 15-12).
4. Check, and if necessary, adjust the air gap between the rear wheel speed sensor and the pulser ring (see page 14-38).
5. Check that the brakes operate correctly.