Disconnect and connect
Disconnect
1. Lift locking tab.
2. Pull the connector housings apart.
Connect
1. Align housings.
2. Press connector housings together until the locking tab clicks.
Remove terminal
PART NUMBER | TOOL NAME |
B-50085 | TERMINAL EXTRACTOR |
1. File the edge of a TERMINAL EXTRACTOR (Part No. B-50085) to a 45 degree angle.
2. Male connector: See Figure A-35. Remove seal (4) from connector housing (2).
3. Lift locking tab on either side of housing and remove secondary lock (3) from connector housing (2).
4. See Figure A-35. Insert the extractor into the cavity next to the terminal. Press the plastic tang away from the terminal.
5. Gently pull the wire to remove the terminal from the connector housing (2).
Install terminal
1. Align terminal to the housing. Install the terminal into the housing. Terminal snaps into place.
2. Gently pull wire to verify terminals are locked.
3. See Figure A-35. Install secondary lock (4) into connector housing (2).
4. Male connector: Install seal (4).
![](https://motoinstruction.ru/img/harley/22/127974.jpg)
Figure A-35. Tyco Super Seal 1.5 Sealed Connector: 1. Terminal; 2. Housing; 3. Secondary lock; 4. Seal