Removal
1. Remove the rider's seat (see page 16-13).
2. Disconnect the battery, negative (black) lead first.
3. Remove the rear rack (see page 16-20).
4. Remove the rear side pa nels (see page 16-21).
Note: The reflector bracket is secured by a nut and bolt located behind the licence plate in all markets where a mudguard extension is not required by law. The rear mudguard extension is installed instead of the splash guard in certain markets as standard, or is available as an accessory from your Triumph dealer. The mudguard extension uses the same fixings as the splash guard shown below, with the addition of a third fixing behind the licence plate.
1. Remove the two lower splash guard or mudguard extension fixings located under the rear mudguard.
1. Splash guard (mudguard extension is similar); 2. Fixings
2. For models fitted with a mudguard extension: Remove the lower fixing located behind the licence plate.
3. All models: Remove the two upper fixings located behind the licence plate.
4. Remove the splash guard or mudguard extension.
1. Fixings; 2. Mudguard extension or reflector bracket fixing (only if fitted)
5. Noting the cable routing, disconnect the rear direction indicator connectors.
6. Remove the two seat rail fir-tree clips.
1. Rear mudguard; 2. Fir-tree clip
7. Lift the rear mudguard off the two rear seat rail lugs, along with the rear light and seat lock assembly.
1. Rear mudguard; 2. Seat rail lugs
8. Carefully separate the rear mudguard from the rear light and seat lock assembly and remove from the motorcycle. Do not allow the rear light and seat lock assembly to hang from the rear light harness or seat lock cable.
Installation
1. Align the rear mudguard to the rear light and seat lock assembly.
2. Position the rear mudguard to the seat rails, and locate the holes in the mudguard over the lugs on the frame.
3. Secure the rear mudguard to the seat rails using new fir-tree clips.
4. Following the routing noted during disassembly, reconnect the rear direction indicators.
5. Refit the splash guard or mudguard extension. Secure the splash guard or mudguard extension with the four screws and tighten to 3 Nm.
6. Install the lower mudguard extension or reflector bracket fixing and tighten to 5 Nm.
7. All models: Refit the rear side panels (see page 16-21).
8. Refit the rear rack (see page 16-21).
9. Reconnect the battery, positive (red) lead first.
10. Refit the rider's seat (see page 16-13).