Prepare
Warning: Gasoline is extremely flammable and highly explosive. Keep gasoline away from ignition sources which could result in death or serious injury. See the Safety chapter.
Warning: To prevent spray of fuel, purge system of high-pressure fuel before supply line is disconnected. Gasoline is extremely flammable and highly explosive, which could result in death or serious injury.
1. Purge fuel supply line. See Fuel line.
2. Remove main fuse. See Power disconnect.
3. Remove air cleaner assembly. See Air cleaner assembly.
4. Lift rear of fuel tank. See Lift rear of fuel tank.
5. Remove fuel rail. See Fuel injectors.
Remove
1. Disconnect TMAP sensor connector.
2. See Figure 6-17. Remove TMAP sensor.
- a. Remove screw (2).
- b. Remove TMAP sensor (1).
Install
FASTENER | TORQUE VALUE | |
TMAP screw | 2.5-4 5 Nm | 23-39 in·lbs |
1. See Figure 6-17. Install TMAP sensor.
- a. Install TMAP sensor (1).
- b. Install screw (2). Tighten to 2.5-4.5 Nm (23-39 in·lbs).
2. Connect TMAP sensor connector.
![](https://motoinstruction.ru/img/harley/22/127858.jpg)
Figure 6-17. Temperature Manifold Absolute Pressure (TMAP) Sensor: 1. TMAP sensor; 2. Screw
Complete
1. Install fuel rail. See Fuel injectors.
2. Secure rear of fuel tank. See Lift rear of fuel tank.
3. Install air cleaner assembly. See Air cleaner assembly.
4. Install main fuse. See Power disconnect.