Removal
1. Remove the rider's seat (see page 16-13).
2. Disconnect the battery, negative (black) lead first.
3. Remove the fixing and remove the air intake duct from the airbox.
1. Air intake duct; 2. Fixing
4. Remove the fuel tank (see page 10-91).
5. Disconnect the intake air temperature sensor multi-plug.
1. Intake air temperature sensor; 2. Multi-plug
6. Disconnect the MAP sensor multi-plug and hose.
1. Map sensor; 2. Multi-plug; 3. Hose
7. Release the 11 fixings and remove the airbox upper section.
1. Airbox upper section; 2. Fixings
8. Release the six fixings and remove the airbox intake trumpets.
1. Airbox intake trumpet fixings; 2. Air filter fixings; 3. Air filter; 4. Air filter fixings
9. Remove the two fixings and remove the air filter element.
10. Remove the airbox rear fixing, located below the air filter.
1. Rear airbox fixing
11. Raise the airbox and disconnect the engine breather hose at the airbox.
1. Engine breather hose; 2. Spring hose clip
12. Remove the airbox from the motorcycle.
Inspection
1. Thoroughly clean the inside and outside of the airbox.
2. Check the airbox and intake trumpets for damage.
Installation
1. Position the airbox to the motorcycle.
2. Connect the engine breather hose and refit the spring hose clip.
3. Align the airbox to the engine breather cover and secure using the rear fixing. Do not fully tighten at this stage.
4. Align the front of the airbox to the throttle bodies and fit the airbox intake trumpets. Tighten the fixings to 6 Nm.
5. Tighten the airbox rear fixing to 9 Nm.
6. Refit the air filter and tighten the fixings to 1 Nm.
7. Refit the airbox upper section and tighten the fixings to 1.5 Nm.
8. Reconnect the air temperature and MAP sensor multi-plugs.
9. Reconnect the MAP sensor hose.
10. Refit the fuel tank (see page 10-92).
11. Reconnect the battery, positive (red) lead first.
12. Refit the rider's seat (see page 16-13).