Removal
1. Remove the rider's seat (see page 16-13).
2. Disconnect the battery, negative (black) lead first.
3. Remove the alternator cover (see page 17-19).
4. Remove and discard the fixings and detach the cable guide from the crankcase.
5. Remove and discard the fixings and detach the sensor and cable guide from the crankcase.
1. Crankshaft position sensor; 2. Sensor cable guide; 3. Sensor fixings; 4. Upper cable guide; 5. Cable guide fixing
6. Noting its routing, trace the sensor wiring back to the connector. Disconnect the sensor and detach it from the motorcycle.
Installation
1. Position the sensor to the engine and route the wiring as noted prior to removal.
Note: The air gap for the crankshaft position sensor is not adjustable.
2. Retain the sensor with two new fixings. Tighten to 4 Nm.
3. Re-route the harness as noted during disassembly, and reconnect the sensor to the main wiring harness.
4. Refit the alternator cover (see page 17-20).
5. Reconnect the battery, positive identified with red (tape) lead first.
6. Refit the rider's seat (see page 16-13).