Removal
Note: The fall detection switch is located below the rear rack, forward of the rear light unit.
1. Remove the rider's seat (see page 16-13).
2. Disconnect the battery, negative (black) lead first.
3. Remove the rear rack (see page 16-20).
4. Disconnect the multi-plug.
5. Release the fixings securing the switch to the battery tray and remove the switch. Discard the fixings.
1. Fall detection switch; 2. Multi-plug; 3. Fixings
Installation
1. Fit the switch to the battery tray, secure with new fixings and tighten to 3 Nm.
2. Reconnect the multi-plug.
3. Refit the rear rack (see page 16-21).
4. Reconnect the battery, positive (red) lead first.
5. Refit the rider's seat (see page 16-13).